SDD — Blog
If you add leather lacing around the brim of a wide brim hat, the hard part is not the lacing. It is getting the holes evenly spaced and in line all the way around the brim. A wide brim hat lacing template does that marking for you. Here is how ours works, what size hats it fits, and what it does not do.
The template sits on the hat brim and shows you where to put the holes for your leather lacing. You mark through the guide holes, take the template off, and then make your holes. It guides the marking. It does not punch or cut the holes, and it does not include the leather lacing.
The template is made for wide, flat-brim hats. The overall outside brim has to be smaller than 395 mm by 365 mm. To check, measure your hat edge to edge across the brim at its widest and longest points. If both measurements are under those numbers, it fits.
The physical template is $32.86. We make it and ship it to you in sections with glue included. Pick this if you just want the template.
The STL file is $9.87. You print it yourself, so you need a 3D printer and slicing software. Print it at original scale so the fit and the 7 mm holes stay correct. The template is made of several parts, so check that your printer can fit each part. The file is for personal use only, so it cannot be sold, shared, or redistributed.
No. It guides your marking. You make the holes with the tool you prefer.
Wide, flat-brim hats with an overall outside brim smaller than 395 mm by 365 mm, measured edge to edge.
Yes. It is reusable.
No. It ships in sections with glue included, and you assemble it.
A 3D printer and slicing software. Print it at original scale, and make sure your printer can fit each individual part.