SONGDAWG DESIGNS
Laser Engraving & 3D Manufacturing
Magnetic Laser Bed Hold Downs – Dual-Sided Honeycomb Clamps with N52 Magnets and Non-Slip Grip
Ships from Santaquin, UT
$28.87
Shipping is calculated at checkout by weight (typically $8–$18). Ships from Santaquin, UT.
📧 Order confirmation and digital download emails sometimes land in spam/junk — check there if you don't see it within a few minutes of checkout.
SongDawg Laser Stiks are magnetic laser bed hold downs designed to keep thin sheets flat, secure, and properly positioned on a steel honeycomb laser bed. Stop fighting warped plywood, lifted corners, and shifting material — Laser Stiks use a reversible edge lip to hold your material down while keeping a low profile around the work area. Pressed, surface-mounted N52 magnets provide maximum direct holding power. Textured, knobby underside grips the honeycomb and resists sliding. Reversible design supports two material thicknesses with one Stik — flip it over to select the lip that matches your material. Built-in finger tabs make removal easier. Interlocking ends connect in parallel for longer edges, and Stiks also connect at 90 degrees to secure material corners (standard design only). No screws, tools, or permanent bed modifications required. Standard Laser Stiks measure 250mm long x 30mm wide (interlocking design), available in 3-pack or 6-pack, each in your choice of 1.5mm/3mm or 3.5mm/5mm lip thickness. Big Stiks measure 350mm long x 30mm wide for additional coverage on large sheets of material, sold in sets of 2, also available in 1.5mm/3mm or 3.5mm/5mm. Designed for steel honeycomb beds and other ferromagnetic laser-bed surfaces — magnets will not attach directly to aluminum, though a thin steel sheet can be placed beneath the work area when using an aluminum bed. Material, laser bed, and other items shown in the photographs are not included.